TV Cabinet

Last winter we had some of our barn renovated into a new living room. Natalie has gone crazy with the retro look in here, and we just put in the second-to-last piece, a good looking spot for the TV (I'm still nagging her to just drop the hammer on an Eames lounge...).

We had been looking for a while for a '60s hi-fi console, but she found them too big, and they're really not deep enough to fit things like computers and large receivers. My requirements were 18" for the PC to fit comfortably, for instance. At one point I told her to give up on those, and just look for dressers that matched the depth requirement, here's what she found, for $55:

For reasons that aren't entirely clear to me, I decided that Step One was to rip the pressed board back off. We still have it, and it should honestly probably go back on with appropriate holes drilled. I really don't remember what I was thinking.

Anyway, we shimmed the drawer holes so things would fit flat without taking out the drawer track. The goal was to do as little damage to this thing as possible, just in the case we want to use it as a dresser, or re-sell it or whatever later. None of those things are going to happen. Here's that interim state:

And a wider view of how it fits in the room:

To cover the holes I had suggested some cool amp grille cloth fabric, but we actually had some pretty good stuff on-hand. It also has the advantage of not having a really tight pattern, so if it's stretched more in parts, you can't tell. The grilles are then held on by cabinet magnets. So the extent of the modification of the dresser is 12 screws to hold the metal plates the magnets stick to:

Done:

I may take some black cloth and add it to the inside, just to block 100% of the LED light when all the room-lights are off, but with the lights on, you can't see anything.